用差示分光光度法测定高浓度皮革废水中铬的方法探讨

介绍了应用差示分光光度法直接测定高浓度皮革废水中Cr的方法，通过与原实验方法分析结果的对比，获得了满意的结果，能基本满足环境监测的要求。     

气浮+生物接触氧化工艺处理食品加工废水

通过气浮 生物接触氧化工艺处理速冻食品加工废水的实验、设计和工程运行,结果表明:废水COD去除率能达到97%以上,使得最终出水的COD＜100mg/l.该工艺对冲击负荷有较强的适应性.     

The Ethics of Constrained Choice: How the Industrialization of Agriculture Impacts Farming and Farmer Behavior

The industrialization of agriculture not only alters the ways in which agricultural production occurs, but it also impacts the decisions farmers make in important ways. First, constraints created by the economic environment of farming limit what options a farmer has available to him. Second, because of the industrialization of agriculture and the resulting economic pressures it creates for farmers, the fact that decisions are constrained creates new ethical challenges for farmers. Having fewer options when faced with severe economic pressures is a very different situation for farmers than having many options available. We discuss the implications of constrained choice and show that it increases the likelihood that farmers will consider unethical behavior.     

地下停车库空气污染物排放实测研究

通过对上海市某商业地下停车库库内及排风管道的连续监测,获得了CO、NO、非甲烷总烃(NMHC)、PM10等空气污染物浓度数据。结果表明:(1)地下停车库的休息日车流量明显大于工作日,且工作日小时车流与车位比为20%~50%、休息日小时车流与车位比为20%~80%。(2)总体上,地下停车库内CO、NO、NMHC浓度呈明显变化规律,营业时间现峰值,非营业时间现谷值;地下停车库内CO、NO、NMHC变化规律和车库排风中具有较好的一致性。(3)车库排风中污染物浓度水平均低于地下停车库内。(4)营业时间的CO、NO、NMHC小时浓度平均值明显增大,约为非营业时间的2.42~3.67倍。(5)单车次CO、NOX、NMHC排放量最大值分别为0.855、0.070、0.214g/(辆·次)。(6)营业时间,除地下停车库内CO外,NO、PM10的8h时间加权平均值符合《工作场所有害因素职业接触限值化学有害因素》(GBZ 2.1—2007,其中未规定NMHC)中时间加权平均容许浓度(PC-TWA);地下停车库内CO出现33.3%的超标频率,最大占标率104%。     

悬挂链生物接触氧化工艺处理河道污水

采用悬挂链曝气式接触氧化工艺在3个时段内处理城市河道污水,通过采用磷脂法、TTC-脱氢酶活性法和MPN法研究载体表面生物膜特性,来验证装置的水质净化效果。结果表明,进水水质变化幅度较大的时段1内,水质对缺氧区和好氧区内生物膜量及活性有很大冲击,对污染物的去除效果影响不大,COD、NH+4-N、TN和TP的平均去除率分别达到75.9%、80.8%、64.6%和78.3%;进水水质稳定的时段2内,缺氧区和好氧区内生物膜量和活性要高于其他时段,COD、NH+4-N、TN和TP的平均去除率分别达到77.0%、80.6%、69.4%和55.3%;低温运行的时段3内,缺氧区和好氧区内生物膜量和活性都低于其他时段,水质净化效果明显下降,COD、NH+4-N、TN和TP的平均去除率分别为71.1%、68.5%、48.9%和46.6%。     

焊点热疲劳失效原因分析

某PCBA样品在使用约半年后出现功能失效,该PCBA在封装后进行整体灌胶,将失效样品剥离,发现部分器件直接脱落,通过表面观察、切片分析、EBSD分析、应力分析、热膨胀系数测试等手段对样品进行分析,结果表明:各封装材料存在热失配,且焊点缺陷较多且存在应力集中区,加速焊点的疲劳失效进程,导致PCBA功能失效。     

Evaluating the impact of uncertainty and variability on the value chain optimization of a forest biomass power plant using Monte Carlo Simulation

Mathematical programming models have been used to optimize the design and management of forest bioenergy supply chains. A deterministic mathematical model is beneficial for making optimum decisions; however, its applicability to real-world problems may be limited because it does not capture all the complexities, including uncertainties in the parameters, in the supply chain. In this paper, a combination of Monte Carlo Simulation and optimization model is used to evaluate the impact of uncertainty in biomass quality, availability and cost, and electricity prices on the supply chain of a forest biomass power plant. The optimization model is a deterministic mixed integer non-linear model with monthly time steps over a 1-year planning horizon. Variability in biomass quality, i.e. moisture content (MC) and higher heating value (HHV), based on the historical data of a real case study is studied in detail and fitted probability distributions are used in the model, while for electricity prices different scenarios are considered. The results show that the impact of variability in the MC on profit is higher than that of uncertainty in HHV. It is observed that the annual profit ranges between $13.3 million and $17.9 million in the presence of all possible uncertainties while its average is $15.5 million. Uncertainty in biomass availability and cost and electricity price results in the risks of having annual profit of less than $14 million and low monthly storage levels.     

燃煤电厂在线监测系统颗粒物浓度排放系数影响因素的探讨

选取上海市7家未安装气-气换热器的国控燃煤电厂作为研究对象，从煤质、除尘器、脱硫协同脱除作用以及锅炉工况负荷等方面探讨对颗粒物浓度排放系数 K值产生的影响，得出上述因素通过改变脱硫进口颗粒物浓度值影响 K值，当脱硫进口颗粒物浓度较低、波动范围较小时，其 K值也维持相对稳定的状态；当脱硫进口颗粒物浓度较高、波动范围较大时，其 K值也会发生较大的变化等结论。     

燃煤机组烟囱在线烟尘仪监测烟尘浓度偏高原因分析及对策

除尘电价补贴政策的出台以及新环保标准的实施，一方面提高了电厂降低烟尘排放浓度的积极性，另一方面对烟尘在线监测系统提出了更高的要求。针对一些采用湿法脱硫和无GGH的燃煤机组，会出现烟囱在线烟尘仪监测的烟尘浓度高于电除尘器出口烟尘的浓度，对产生这一现象的原因进行了分析并提出相应的解决对策。     

Experimental research of LNG accidental underwater release and combustion behavior

Evaluating potential hazards caused by accidental LNG release from underwater pipelines or vessels is a significant consideration in marine transportation safety. The aim of this study was to capture the dynamic behavior of LNG jet released under water and to analyze its vapor dispersion characteristics and combustion characteristics on the water surface during different release scenarios. Controlled experiments were conducted where LNG was jet released from a cryogenic storage tank. The dynamic process of LNG being jet released from orifices of different sizes and shapes, as well as the rising plume structure, were captured by a high-speed camera. The leakage flow rate and pipeline pressure were recorded by a flow meter and pressure gauge, respectively. The concentration distribution that emanated from the water surface was measured utilizing methane sensors in different positions with various wind speeds. The flame combustion characteristics of LNG vapor clouds, which immediately ignited upon the enclosed water tank, were also recorded. Additionally, the mass burning rate of the flame on the water surface was evaluated, and a new correlation between the ratio of flame length and width was established. The results indicated a large dimensionless heat release rate (Q*) and a continuous release flow rate in a limited burning area. This study could provide greater understanding of the mechanisms of LNG release and combustion behavior under water.